Kratky watercress method

From Kratky Method Hydroponics, a reference on passive, non-circulating hydroponics

Part of Kratky system designs.

Watercress method
CropWatercress (Nasturtium officinale)[1]
PublishedCTAHR Vegetable Crops VC-7, June 2015[1]
TankPolyethylene-lined, 5½ in deep or deeper[1]
CoversSuspended (on the frame) or floating[1]
Sowing10 to 20 seeds per 2-inch net pot[1]
SolutionEC 1.7–2.5 mS[1]
Crop time3 to 5 weeks from transplanting[1]
RegrowthRatoon ("cut and come again") crops possible[1]

The Kratky watercress method grows watercress from seed in a covered, polyethylene-lined tank of nutrient solution, with no electricity or pumps. Bernard Kratky described two versions in a 2015 University of Hawaii bulletin: a suspended cover resting on the tank frame, as in his lettuce tanks, and a cover that floats on the solution.[1] An entire crop can be grown on one fill, but unlike lettuce, watercress tolerates later additions of water, so the tank can be kept topped up for a regrowth crop.[1]

Tank and solution

Tanks are at least 5½ inches deep, and deeper is better. A separate, undated Kratky handout builds them by draping two layers of 6-mil polyethylene over a lumber frame on a level surface, and notes that a plastic storage container also works.[1][2] A 5½-inch-deep, 4 × 8 ft tank holds 110 gallons.[2]

The handout gives two ways to fertilize: 1 teaspoon of Chem-Gro 10-8-22 per gallon of water, or two stock solutions (A: 1 lb of Chem-Gro 8-15-36 and 0.6 lb of magnesium sulfate per gallon; B: 1 lb of calcium nitrate per gallon), added at ½ ounce of each per gallon of tank water. It suggests an EC of 1.5 to 2.0 mS and a pH of 5.0 to 7.0.[2] The 2015 bulletin's diagrams show an EC of 1.7 to 2.5 mS.[1]

The two covers

Suspended and floating covers for watercress[1]
Suspended coverFloating cover
Cover1-inch expanded or ½-inch extruded polystyrene, 2 × 4 ft sheets on the tank frame½ to 1-inch extruded polystyrene, cut ½ to 1 inch smaller than the tank
Net pot depth in solutionLower ½ to 1 inch at the startLower 1 to 1½ inches throughout
Air spaceOpens as the level falls; roots in it become oxygen rootsNone
At harvestHarvest before the solution runs outKeep at least 2 inches of solution

Beadboard does not suit the floating cover, because its air pockets let it waterlog and grow algae. A strip of dark plastic over the gap between a floating cover and the tank sides reduces algae.[1] How the two covers compared in Kratky's trials is covered under evidence for the air space.

Sowing

Two-inch net pots are filled with a peat-perlite medium and sown with 10 to 20 watercress seeds each, or planted with a similar number of seedlings one to three weeks old.[1] The handout sows the seed on the surface without covering it, suggests a shaker made from a plastic tube with a 5/64-inch hole in the cap, and notes that seeds usually germinate within 3 days. Its spacing is a staggered 8 × 12 inches, or 1.5 plants per square foot.[2]

Harvest and ratoon crops

The 2015 bulletin puts the crop at 3 to 5 weeks from transplanting; the handout says plants grow for 4 to 6 weeks from seeding without attention.[1][2] Watercress is cut with scissors, preferably in the morning or evening, leaving 1½ inches of stubble to regrow.[2]

After harvest the tank can be cleaned and refilled for a new crop, or a ratoon crop can be taken: the level is kept up with periodic additions of solution, and a second cut follows 3 to 4 weeks later. The tank is then drained, the net pots cleaned and the process repeated.[1][2] For ratoons harvested monthly, changing the solution completely every two months gave 49 percent more watercress over six months than topping off alone.[1]

Growing conditions

  • Temperature and elevation. Watercress prefers cooler temperatures, and summer crops at low elevation give variable results.[2] Even so, over eight crops in one year it yielded 32 percent more in 19 percent less time at the warmer Mealani station (2,800 ft) than at Volcano (4,000 ft).[1]
  • Light. A 40 percent shade fabric reduced yields by 15 percent over eight harvests.[1]
  • Rain. Unlike lettuce in the suspended-pot method, watercress tolerates rain entering the tank, so rain shelters are not mandatory, though rain dilutes the solution and can slow growth.[1] See rain shelters in Kratky's research.

Cautions

  • Mosquitoes can breed in the still solution. The handout lists salt-tolerant fish, approved Bacillus thuringiensis subsp. israelensis products, and pesticides labeled for watercress, and notes that cool, dry or windy weather discourages mosquitoes.[2] The research is summarized in mosquito control research in Kratky tanks.
  • Water quality. Salts concentrate as the solution is used; rainwater is recommended where water is poor.[2]
  • Insects. Pest problems are similar to field watercress, but a hydroponic grower can shut down completely between crops to break insect cycles.[2]

See also

References

  1. Kratky, B.A. (2015). Growing Direct-Seeded Watercress by Two Non-Circulating Hydroponic Methods. University of Hawaii CTAHR, Vegetable Crops VC-7. PDF.
  2. Kratky, B. Growing Watercress from Seed by a Non-Circulating Hydroponic Method. University of Hawaii CTAHR, undated handout. PDF.